|
|
|
- Whats New >
- Hardware >
- Pushrod Clevis/Keepers/Etc >
1.5mm (.055") Rod Ends
|
| Pushrod Clevis/Keepers/Etc - Choose your pushrod wire size.
| | | | |
Handy set of 8 black nylon keepers. Fits .055" (1.5mm) push rod wire most commonly used in park fliers and foamys. Black nylon material. Simply bend the end of your pushrod into an "L". Put the L through the servo or control horn. Bend the hand back and clip onto the rod. Simple use, removes and instals quickly. Keeps your push rods from slipping out of the control horns. Light weight, simple and they work great! Photo shows an example of our "Flexi-Keeper" hooked to end of push rod and a control horn. Control horn & wire are not included in set.
SKU Number: RRCFLEXIKEEP055
|
|
|
|
| | |
Four barrels, washers, nuts and set screws. Allen wrench not included, requires 1.5mm. Will work on any rod size 1.5 to 1.85mm (.074"). 2mm pushrods and 2-56 are usually this size or smaller. The threads are rolled and larger than the base wire diameter. Instal in 5/64" (1.9mm) hole.
SKU Number: EZADJRE17
|
|
|
|
| | |
Four barrels, washers, nuts and set screws. Allen wrench not included, requires 1.5mm. Will work on any rod size 1.5 to 2mm (.079"). 2mm pushrods and 2-56 are usually this size or smaller. The threads are rolled and larger than the base wire diameter. Install in 7/64" (2.6mm) hole. TEMPORARILY OUT OF STOCK
SKU Number: EZADJRE20
|
|
|
|
| |
 "Radical RC Flexi-Keepers .055\" (1.5mm) Wire L Bends 8 Pack")
 "1.5mm/2mm/2-56 EZ-A-Just Rod Ends up to 1.8mm shafts")
 "1.5mm/2mm/2-56 Heavy Duty EZ-A-Just Rod End up to 2mm Shafts")